Bellhousing adapter
Moderators: Greenleaf, KTA, BC847, Richie O
2 posts
• Page 1 of 1
Bellhousing adapter
by DDT » Wed Dec 16, 2009 6:06 pm
I have obtained a 47rh transmission and need the adapter from the same donor....95 2500.. I have been unable to get the torque converter off because the engine was given the cash for clunkers lockdown treatment and I can't turn it to access the converter bolts. Somebody stop me before I light the torch!
9 3 W350 Club Cab,DRW, K&N filter, pump adjusted, 366 spring, 16cm GDS 60cm, 4 in exhaust, Diprocal boost/EGT, PODs on the way out
- DDT
- fuel pin?
- Posts: 6
- Joined: Sat Feb 07, 2009 7:58 am
- Location: Johnston, SC/Summerville, GA
by PToombs » Wed Dec 16, 2009 6:16 pm
Is the engine out? If so, pull the pan and loosen the bearing caps, should turn then. If not, torch time! 
Or, just order a good converter, and turn in your old one in the truck as a core.
FYI, lockup converters are usually about $1200.
Or, just order a good converter, and turn in your old one in the truck as a core.
FYI, lockup converters are usually about $1200.
pete
Just enough power to break everything behind the crankshaft.
Just enough power to break everything behind the crankshaft.
-
PToombs - 14mm rotor
- Posts: 11369
- Joined: Sun Jan 07, 2007 6:13 pm
- Location: Syracuse NY. Snow central!