new injectors

[gomerpile]

ok so i now have some bosch 190's on their way , so heres my question. what is the exact process to changing them, i says i comes with intall kit. i am going to make this http://www.dieseltruckresource.com/dev/showthread.php?t=124728 to remove them, now what do i have to get out of the bore after i got out the injectors?(washers,gunk, etc.) any tips/tricks i need to know?

[6LCummins]

you will want to get the seals out and make sure u use an injector bore brush to clean up the injector holes. other than that it is pretty easy and straight forward.

[PToombs]

Watch the old injectors when you pull them. If the washers are on the injector, you can see it, and don't have to worry about them in the hole. I just blow some air in there to blow the crud out. A wire brush first would help.

[CumminsPride]

Before you start, I recommend some engine degreaser and a pass with the pressure washer:) !

Wade