by thrashingcows » Thu Mar 19, 2015 11:06 am
The fans on the cummins motor are pretty much diesel specific. The way they bolt to the clutch fan assembly, the off set, and the width of the overall fan make them pretty much a specific piece.
I tried tgo make a gasser fan "work", but as I stated above there was too many specific parameters that had to be met to make it work properly. To my knowledge there are no aftermarket type replacement fans available for the 1s Gen's.
As I mentioned the 2nd Gen 12V and maybe the 24V fans will work.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.
Check out the build....
http://www.dieseltruckresource.com/dev/ ... 05923.html