by LandTug2 » Mon Mar 23, 2015 1:38 pm
Well ordered some 6x16 injectors from Rocken Tech. Heard mixed reviews but thought I would give them a go. Told them I needed injectors for a 93 intercooled CTD. They said no problem, shot a set out. First off they sent 9mm injectors instead of 7mm injectors. Sent them an email and they shot out another set speedily. Just got them all in happy I had the right ones and went to put the lines on just to find that the male end of the injector is too big for the stock fuel line fitting! Looked at their website and saw that it says M14x 1.5 orifice size and I believe ours are M12x 1.75... . Why would they do this in the first place??? Do they expect us to have aftermarket lines? Has anyone else run into something like this? If so, what was the remedy?
'93 D250 5x16s, Stg1 pin, 3200 gov spg, stiffer afc spring, pump tuning, Super Harmonic Damper, Timing Spacer, hx35/ht3b compounds, 100 gpm lift pump, 12" Cone filter, Moog Springs, pyro/drive pressure/boost/f. pressure/tach gauges,valet switch, 4'' straight pipe, mag hitec dif cover