VE Pump Control valve oring seal question

How the engine works

Moderators: Greenleaf, KTA, BC847, Richie O

VE Pump Control valve oring seal question

Postby rustybottoms88 » Sat Nov 18, 2017 6:23 am

Are specific seals in the Bosch DGK121 kit that go on the control valve? I found two sets of three seals that were similar OD but different thickness. I put the thinner seals on and it's leaking. I plan to take it apart and see what's up but thought I would check and see if I could round up more info. Any help is appreciated.
fuel pin?
Posts: 11
Joined: Wed Nov 15, 2017 12:36 pm

Re: VE Pump Control valve oring seal question

Postby thrashingcows » Sat Nov 18, 2017 5:36 pm

I have never measured them, just remove them and find ones in the pack that look as close as possible, never had a leak.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.

Check out the build.... ... 05923.html
14mm rotor
Posts: 576
Joined: Wed Nov 02, 2011 12:00 am

Return to Engine

Who is online

Users browsing this forum: No registered users and 1 guest