VE Pump Control valve oring seal question

How the engine works

Moderators: Greenleaf, KTA, BC847, Richie O

VE Pump Control valve oring seal question

Postby rustybottoms88 » Sat Nov 18, 2017 6:23 am

Are specific seals in the Bosch DGK121 kit that go on the control valve? I found two sets of three seals that were similar OD but different thickness. I put the thinner seals on and it's leaking. I plan to take it apart and see what's up but thought I would check and see if I could round up more info. Any help is appreciated.
rustybottoms88
fuel pin?
 
Posts: 11
Joined: Wed Nov 15, 2017 12:36 pm

Re: VE Pump Control valve oring seal question

Postby thrashingcows » Sat Nov 18, 2017 5:36 pm

I have never measured them, just remove them and find ones in the pack that look as close as possible, never had a leak.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 575
Joined: Wed Nov 02, 2011 12:00 am


Return to Engine

Who is online

Users browsing this forum: No registered users and 8 guests

cron