TPS Throttle Position Sensor

How the engine works

Moderators: Greenleaf, KTA, BC847, Richie O

TPS Throttle Position Sensor

Postby Bersaglieri » Sun Nov 25, 2018 8:51 pm

I am trying to wire a US Shift Quick4 transmission control to run a 1992 12v Cummins ahead of a 4R100. It looks like I have two options to use for the TPS input. The factory Dodge TPS on top of the pump or the Ford one [they call it the acceleration pedal position sensor] located at the fuel pedal.

How good or bad are the TPS units on the pump? What voltage range do they have? Reliable output?

The one on the pump would be ideal since, being connected directly, it should read in line with the fueling. However, if I use the Ford one I am going to have to phase the pedal and the pump linkage together so that pedal input matches fuel output.

Thanks.
1997 Ram 2500 P7100 6BT - G56 - Dana
2002 Excursion VE 6BT- 4R100 - Sterling
Bersaglieri
fuel pin?
 
Posts: 10
Joined: Sat Sep 08, 2018 5:00 pm

Re: TPS Throttle Position Sensor

Postby Philip » Mon Nov 26, 2018 7:10 am

5 Volt is the input voltage. Output is 0 to about 4 volts.

Some people whine about the Dodge units being trash. I replaced one on my truck in the 12 years it had a auto in it.
93 W350 Club/cab w/duals, buckets & console, B&W flatbed, G56, 6 spd, 3:07 rears, gages, HX40/16, 4" exhaust, 6X.018 sticks, rear air ride suspension
User avatar
Philip
14mm rotor
 
Posts: 1918
Joined: Mon Jan 08, 2007 10:50 am
Location: Indiana


Return to Engine

Who is online

Users browsing this forum: No registered users and 1 guest