Injector Tourque #?
Moderators: Greenleaf, KTA, BC847, Richie O
3 posts
• Page 1 of 1
Injector Tourque #?
by TTipswprd » Sat Oct 31, 2009 9:48 am
Finally got my new injectors ordered. seeing as how ive never done injectors before i was wondering if anyone could tell what i should torque them in at?
1992 w250 4x4, pump tuned, custom exhaust, intake, and dennyT fuel pin, cooler tubz, 5x.014's from SDX
- TTipswprd
- fuel screw!!!!
- Posts: 138
- Joined: Thu Aug 13, 2009 5:14 pm
- Location: Cheyenne Wy
by TWorline » Sat Oct 31, 2009 10:38 am
The Factory Service Manual calls for 44ft. lbs. on the injector retaining nuts, 6 ft. lbs. for the return line banjo bolts and 18 ft. lbs. for the injector supply line.
Tim Worline
1992 W250 Club Cab LE, S300 62/71, 5" stainless intake, 4" into 5" exhaust, ATS exhaust manifold, SDX 5X18 Injectors, AirDog 150, Borgeson shaft, Coolingmist Vari-cool, Con OFEK, 3" Stainless CoolerTubz, 354/749.
http://www.CoolerTubz.com/
1992 W250 Club Cab LE, S300 62/71, 5" stainless intake, 4" into 5" exhaust, ATS exhaust manifold, SDX 5X18 Injectors, AirDog 150, Borgeson shaft, Coolingmist Vari-cool, Con OFEK, 3" Stainless CoolerTubz, 354/749.
http://www.CoolerTubz.com/
-
TWorline - 14mm rotor
- Posts: 2480
- Joined: Thu Jan 04, 2007 6:32 pm
- Location: Continental, Oh.