intake bolt torque specs
Moderators: Greenleaf, KTA, BC847, Richie O
3 posts
• Page 1 of 1
intake bolt torque specs
by rook440 » Tue Dec 15, 2009 6:40 pm
I need the torque specs for the intake manifold , I just replaced the gaskets and I need the torque specs and I assume that you start in the center and work out both ways ....thanks Rook
- rook440
- fuel pin?
- Posts: 6
- Joined: Sat Jan 05, 2008 10:14 pm
- Location: creston Iowa
by dpuckett » Tue Dec 15, 2009 6:43 pm
A quarter turn before stripping or breaking. Seriously, though, 18ft-lbs rings a bell. Honestly, I just tighten them down with my hand on the center of the ratchet til I cant go anymore.
His- 93 W250 club cab LE, auto to Getrag conversion, piston lift pump, 3.54 LSD. 400k+
Hers- 04 QC 4x4. Built auto, Triple Dog, Air Dog. Funny Round truck that aint so quiet.
Hers- 04 QC 4x4. Built auto, Triple Dog, Air Dog. Funny Round truck that aint so quiet.
- dpuckett
- 14mm rotor
- Posts: 2196
- Joined: Wed Jan 03, 2007 4:33 pm
- Location: Perryville MO
