I just added a US gear exhaust brake and want to put 60# exhaust valve springs in. can I do this with out haveing the head removed ?
thanks
60# valve spings??
Moderators: Greenleaf, KTA, BC847, Richie O
2 posts
• Page 1 of 1
60# valve spings??
by Kinship » Mon May 07, 2007 3:53 pm
This is my first post here. I have 93 D350 ,NV4500HD conversion,south west clutch,gear vendor,stans 4" ,16cm EX houseing .
I just added a US gear exhaust brake and want to put 60# exhaust valve springs in. can I do this with out haveing the head removed ?
thanks
I just added a US gear exhaust brake and want to put 60# exhaust valve springs in. can I do this with out haveing the head removed ?
thanks
- Kinship
- smoke screw?
- Posts: 3
- Joined: Mon Feb 19, 2007 9:32 pm
- Location: Acton, California
by wannadiesel » Mon May 07, 2007 4:11 pm
Yes. You bring each cylinder to TDC and let the valve sit on the piston.
'93 D350 LE Club Cab dually, Getrag, 3.54 Pow-R-Lok with: DPS EDM's, HTT Stage IV/14wg, Con-FE, Snow Stage 2 water/meth, custom fuel pin, Walbro secondary fuel system.
Best dyno: 408/844
Best dyno: 408/844
-
wannadiesel - diesel guru
- Posts: 358
- Joined: Mon Jan 01, 2007 6:25 pm
- Location: New Holland, PA