Holset Super 40 And PacBrake
Moderators: Greenleaf, KTA, BC847, Richie O
2 posts
• Page 1 of 1
Holset Super 40 And PacBrake
by doublel89 » Thu Feb 04, 2010 7:14 pm
Super 40 Turbos have an 4" exhaust outlet i belive correct? are there any options for mating up a PacBrake exhaust brake to the back of one of these bigger turbos?
91 3/4 Ton 4x4, 5.9 Cummins,DDP Fuel Pin I usually leave it out though, DDP 40 Horse Sticks, HX35W And 2nd Gen Intercooler, Single 5'' Trunout, NV5600 Swap, Dually Conversion, 3.08 Rear Gears, Soon A Custom Hauler Bed
- doublel89
- fuel screw!!!!
- Posts: 79
- Joined: Fri Jul 18, 2008 1:58 pm
- Location: Wilson WY
by Philip » Fri Feb 05, 2010 5:48 am
They do make them for 4" outlets. Just watch if your buying a used one and make sure it has a flat flange for mounting. Some HX40's have a beleveled flange setup.
93 W350 Club/cab w/duals, buckets & console, B&W flatbed, G56, 6 spd, 3:07 rears, gages, HX40/16, 4" exhaust, 6X.018 sticks, rear air ride suspension
-
Philip - 14mm rotor
- Posts: 1954
- Joined: Mon Jan 08, 2007 10:50 am
- Location: Indiana