On board air- for flat repair ?

[ellis93]

I'll lay odds that you're going to rattle one loose with your mighty impact here in the next week or so, then you'll be cussing ME about it.

Mark.

Nonsense! I don't have to wait till then,can do that now

[Mark Nixon]

Just as well, cuss away.

Mark.

[oldestof11]

Either way you look at it, they both work. The previous owner texted me the other night asking how the truck was. After telling him about the head gasket, I asked how he tightened my lug nuts. Told me his grandpa did it with a 4 way. I don't care what tool it is, if I have to use a 1/2" breaker bar with a 4ft pipe to break them loose, it was too tight.

[dazedandconfused]

People hate when i tighten things especially when they have to take them back apart. I guess i sont know my own strength. Might be since im such a little guy.

[BC847]

Just run a 1/2" line from the engine's intake-log, through a check-valve, and into a large tank mounted under one of the rear fenders.