Moderators: Greenleaf, BC847, Richie O
bgilbert wrote:Keep it a secret! Those of us that do it for a living (on the side) don't want anyone knowing how to build themlol.
ellis93 wrote:I've never used any "special" tools,I've had to be "creative" tho
stillsmokin wrote:ellis93 wrote:I've never used any "special" tools,I've had to be "creative" tho
I never used any special tools on the getrag either, on the NV4500 some tools are mandatory... Like the "wrench" for the 5th gear nut and the mainshaft holding socket. I also use a 10 ton otc push puller and a bearing separator plate to pull alot of the bearings off since alot of the parts won't fit in an average 20 ton hydraulic press. I use my old lathe quite a bit too, to make drivers and other tools, and to shorten the input bearing retainers for AA bellhousings.
revemup15 wrote:Are the internals of a gas nv4500 same as diesel nv4500 besides the input?
bgilbert wrote:Keep it a secret! Those of us that do it for a living (on the side) don't want anyone knowing how to build themlol.
Users browsing this forum: No registered users and 14 guests