HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Off topic/not diesel related

Moderators: Greenleaf, BC847, Richie O

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby BILTIT » Sun Feb 02, 2014 7:42 pm

Lol, I edited it. Best gas engine. I don't think I would want to put a cummins in this boat, it would be too darn heavy!!
Derek B.
2003 QuadCab, Tater 62/65 341cw, Smarty Touch SW9, Full Billet trans.
91.5 W250, coolertubz, HE351CW, PS IC, Alcans, GVOD, Valair DD, bags, crossover.
1974 Pontiac Ventura,best of 11.97 at 112 so far.
Aluminum heads and roller cam on the way.
User avatar
BILTIT
14mm rotor
 
Posts: 711
Joined: Wed Aug 11, 2010 1:29 pm
Location: Lloydminster, Saskatchewan

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby ellis93 » Sun Feb 02, 2014 7:56 pm

BILTIT wrote:I run the best gas engine out there in my boat.........455 Pontiac!!!

Image
Image

Sweet boat!
I can just see John candy being pulled on skies behind it by Dan ackroid :lol:
Now what movie was that ? :)
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7761
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby AHineman » Sun Feb 02, 2014 8:51 pm

The Great Outdoors.....good movie.
Andrew

Owner of two old 1stgens and not much else.
AHineman
14mm rotor
 
Posts: 1364
Joined: Tue Aug 11, 2009 7:15 pm
Location: Crown City, Ohio
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby RCCUMMINS89 » Tue Feb 04, 2014 9:08 am

-6 this morning..... That's really cold for Feb, where I'm at. The wife's car actually froze to the ground, I've never seen that before. One tire could spin, the rest were stuck. I had to pull it free with the truck :roll:
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby BILTIT » Tue Feb 04, 2014 11:39 am

That is cold, i am at the same temp. Cold with our wind anyways. -6 and feels like -26 with the wind, so says the weather folks.
Derek B.
2003 QuadCab, Tater 62/65 341cw, Smarty Touch SW9, Full Billet trans.
91.5 W250, coolertubz, HE351CW, PS IC, Alcans, GVOD, Valair DD, bags, crossover.
1974 Pontiac Ventura,best of 11.97 at 112 so far.
Aluminum heads and roller cam on the way.
User avatar
BILTIT
14mm rotor
 
Posts: 711
Joined: Wed Aug 11, 2010 1:29 pm
Location: Lloydminster, Saskatchewan
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby RCCUMMINS89 » Tue Feb 04, 2014 11:49 am

Supposedly we are supposed to get up to 35mph winds this afternoon. It is starting to get windy, but it is like 8 degrees out right now.


On a side note, I found that my block heater is no longer working. Considering it was supposedly -13 at the lowest in my little city............ and I have;

1. Block heater doesn't work
2. Approx. 80 Bagillion degrees of timing
3. No KSB, grid heater, nor fuel heater (not that the ksb or fuel heater do anything)

That equals to an incredibly hard start, it did it......but I honestly didn't think it was going to after the first 20 seconds or so and it wasn't even attempting to fire.
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby Tacoclaw » Tue Feb 04, 2014 12:12 pm

*cough* ether *cough*
1990 W250 4x4
Rattles, growls, whistles, and whines.
User avatar
Tacoclaw
14mm rotor
 
Posts: 4108
Joined: Wed Mar 11, 2009 7:50 am
Location: Cheshire, OH
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby BILTIT » Tue Feb 04, 2014 1:52 pm

Yup, ether that sucker!!

Or fix your block/intake heaters and put some cardboard in front of the rad for warmup.
Derek B.
2003 QuadCab, Tater 62/65 341cw, Smarty Touch SW9, Full Billet trans.
91.5 W250, coolertubz, HE351CW, PS IC, Alcans, GVOD, Valair DD, bags, crossover.
1974 Pontiac Ventura,best of 11.97 at 112 so far.
Aluminum heads and roller cam on the way.
User avatar
BILTIT
14mm rotor
 
Posts: 711
Joined: Wed Aug 11, 2010 1:29 pm
Location: Lloydminster, Saskatchewan
Top

Re: HOLY CRAP IS IT FREAKIN COLD!!!!!!!!

Postby RCCUMMINS89 » Tue Feb 04, 2014 3:33 pm

I don't have any issues with it warming up/staying warm. It's just firing that terd up.

I'll have to fix the block heater shortly. It is SO hard on it starting it like that.... it literally makes oil every time I start it when it is that cold out.
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Previous

Return to Lounge

Who is online

Users browsing this forum: No registered users and 9 guests