Hello 1st gen guys!

Off topic/not diesel related

Moderators: Greenleaf, BC847, Richie O

Re: Hello 1st gen guys!

Postby Philip » Fri Sep 30, 2016 7:04 pm

That 68 with the slant in it had 4:88 gears most likely. With that gearing any engine will pull. With a top speed of 50 MPH down hill with the clutch in it wasn't good for going far.
93 W350 Club/cab w/duals, buckets & console, B&W flatbed, G56, 6 spd, 3:07 rears, gages, HX40/16, 4" exhaust, 6X.018 sticks, rear air ride suspension
User avatar
14mm rotor
Posts: 1954
Joined: Mon Jan 08, 2007 10:50 am
Location: Indiana

Re: Hello 1st gen guys!

Postby Richie O » Sat Oct 01, 2016 1:32 pm

Yup, maybe 60 on the pin. :D Gave a good place to burn all the waste oil he could find. If it was black and nasty, in the base it went then shortly after out the exhaust. :lol:
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
User avatar
Richie O
Posts: 4150
Joined: Sat May 17, 2008 9:01 pm
Location: New England


Return to Lounge

Who is online

Users browsing this forum: No registered users and 1 guest