Getting some codes, looking for input...

Shame on you guys

Moderators: Greenleaf, BC847, Richie O

Getting some codes, looking for input...

Postby RamblerReb » Fri Mar 07, 2014 5:52 pm

I took the War Wagon down to the Family Dollar down the road (~3 miles) and the check engine lit up. It ran as normal (indifferently), and when I started it back up the light stayed off. I checked the codes when I got home and saw:

12 (normal)

33 (A/C relay? This truck has never had A/C installed.)

37 (Trans Lock-Up Solenoid? It has no TCC)

41 (Alternator Field Control. Not sure what this one means.)

42 (Auto Shutdown. This has to do with the ASD relay, I'm guessing.)

22 (ECT Sensor. The guage seems to be working.)

11 (Pick-up signal. I replaced the pick-up coil last summer.)

If anyone knows if these codes mean different things than the list I found when applied to a '91 D250 318 with an A518 trans, I'd be thrilled to hear from you.

Thanks in advance for any help!
RamblerReb
smoke screw?
 
Posts: 1
Joined: Fri Mar 07, 2014 5:47 pm

Re: Getting some codes, looking for input...

Postby DodgeFreak » Fri Mar 07, 2014 6:19 pm

Try clearing the codes by disconnecting the battery and see if they come back.
92 D350 Cab and Chassis. Auto stock, wiring gremlins. 330k miles
92 W250 Ext cab rotted completely out. Auto, pump maxed, 215 ppump nozzles, Denny T2 pin.
85 D350 single wheel, converted to cummins, getrag, turned up 2 turns and afc screw flush.
User avatar
DodgeFreak
14mm rotor
 
Posts: 1701
Joined: Sat May 15, 2010 8:14 pm
Location: Iowa

Re: Getting some codes, looking for input...

Postby ellis93 » Fri Mar 07, 2014 7:03 pm

The coolant temp sensor it's referring to isn't for the gauge,it's for the computer. Yes there is two different ones. One one wire (gauge) and a two wire one(computer),the one for the computer tell the computer how much gas to give the engine at startup......basically. Also helps tailor the gas being given.

Do as stated and clear out the codes and come again after you drive it a few times.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7761
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi
Top


Return to Non diesel

Who is online

Users browsing this forum: No registered users and 7 guests