2000 Dodge 2500 Pitman Arm

Shame on you guys

Moderators: Greenleaf, BC847, Richie O

2000 Dodge 2500 Pitman Arm

Postby matthewh » Fri Sep 26, 2014 4:04 pm

Working on replacing the pitman arm on my gf's 2000 Dodge 2500 truck, the 2wd ones. Haven't found torque specs for the big nut on the gear shaft, or the nut for the draglink shaft.

Any help from those who have wrenched on the 2nd Gen trucks

'93 W350 5spd Getrag, 4.10 gears, 83k miles and counting, Mods: LPPP AKA Ma Dually
'54 Dodge M37 6.2/700R4/205, 5.89 gears, WC rear axle
14mm rotor
Posts: 633
Joined: Mon Feb 18, 2013 3:07 am
Location: Boyne City Michigan

Re: 2000 Dodge 2500 Pitman Arm

Postby ellis93 » Fri Sep 26, 2014 5:25 pm

Might be wrong but I use an impact....tighten it till it won't turn anymore,call it good :lol:
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
14mm rotor
Posts: 7750
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi

Re: 2000 Dodge 2500 Pitman Arm

Postby shackwrrr » Mon Mar 02, 2015 9:01 pm

Pitman arm nut is 185 ft lbs

Drag link to pitman arm nut is 65 ft lbs.
1991 w250 RCLB
3 speed auto Non IC truck
fuel screw!!!!
Posts: 34
Joined: Mon Mar 02, 2015 5:47 am

Re: 2000 Dodge 2500 Pitman Arm

Postby ofelas » Tue Aug 11, 2015 5:56 am

Matthew - text me your email address and I will send you the 2000 & 2001 FSM.
R12 = liquid bilit
fuel screw!!!!
Posts: 75
Joined: Mon May 04, 2015 4:02 pm
Location: ON & TX

Return to Non diesel

Who is online

Users browsing this forum: No registered users and 1 guest