1stGen.org

THE place for 1st gens

Skip to content

New to the forum!

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

Post a reply

New to the forum!

Postby jack » Sun Apr 14, 2013 10:18 pm

Good Day to All,

I am new to this forum I recently joined this forum and this looks very helpful for me here a lot of information I found and also want to thank member to share the problems and solutions.

Thanks to all again and I hope I will enjoy.
jack
 
Top

Re: New to the forum!

Postby RCCUMMINS89 » Mon Apr 15, 2013 3:10 am

Welcome.

details/pics of your truck?
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Re: New to the forum!

Postby ellis93 » Mon Apr 15, 2013 4:55 am

RCCUMMINS89 wrote:Welcome.

details/pics of your truck?


Ditto ;)
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7761
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi
Top

Re: New to the forum!

Postby BC847 » Mon Apr 15, 2013 7:42 am

jack wrote:Good Day to All,

I am new to this forum I recently joined this forum and this looks very helpful for me here a lot of information I found and also want to thank member to share the problems and solutions.

Thanks to all again and I hope I will enjoy.

Where ya from, Jack?
David

1993 12mm VE Fueled W250 CC, Green
12.67 @ 103.35
Your basic farm truck ;)
BC847
Administrator
 
Posts: 2203
Joined: Wed Jan 03, 2007 5:22 pm
Top

Re: New to the forum!

Postby CumminsPower59 » Mon Apr 15, 2013 8:30 am

Welcome!
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!
Top

Re: New to the forum!

Postby tampabayBill » Thu Apr 18, 2013 7:18 am

I'm betting Nigeria !
93D250 CC LE, 62/65/13 S300, PDR cam,DDP3's, B&D IP, 366 GSK, M3 & timing device, Air Dog 150, Cooler tubes, 3 piece manifold, BHAF & 4" tbe, ported & O ringed, ARP studs, 60# springs 47RH & 3 disc conv., fp, aux trans cooler, fluid damper, 3:54 D70 w/trac-lok, rear sway bar, gauges = egt,boost, tach, 47RH & diff. temps.
Twins coming soon!
tampabayBill
fuel screw!!!!
 
Posts: 293
Joined: Sat Oct 09, 2010 7:51 am
Location: New Port Richey, Fla.
Top

Re: New to the forum!

Postby dustin_mud » Fri Apr 19, 2013 5:19 pm

Welcome to the forum
dustin_mud
fuel screw!!!!
 
Posts: 42
Joined: Sat Oct 27, 2012 8:26 pm
Top

Re: New to the forum!

Postby BC847 » Thu Apr 25, 2013 9:36 am

tampabayBill wrote:I'm betting Nigeria !

Try Pakistan.
David

1993 12mm VE Fueled W250 CC, Green
12.67 @ 103.35
Your basic farm truck ;)
BC847
Administrator
 
Posts: 2203
Joined: Wed Jan 03, 2007 5:22 pm
Top
Post a reply

Return to Welcome

Who is online

Users browsing this forum: No registered users and 25 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group