1stGen.org • View topic - florida newbee

florida newbee

Moderators: Greenleaf, BC847, Richie O

8 posts • Page 1 of 1

florida newbee

by sweetdreamz » Thu May 16, 2013 9:05 am

New guy from florida, glad to be here. My truck is actually a 2nd gen cummins with a 1st gen motor in it, hopefully I can do all my research here.

sweetdreamz: smoke screw?; Posts: 4; Joined: Thu May 16, 2013 9:02 am

Top

Re: florida newbee

by ellis93 » Thu May 16, 2013 10:00 am

Welcome!

93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz

ellis93: 14mm rotor; Posts: 7761; Joined: Wed Feb 17, 2010 3:16 pm; Location: lucedale,mississippi

Top

Re: florida newbee

by RCCUMMINS89 » Thu May 16, 2013 11:54 am

Welcome............

89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.

RCCUMMINS89

14mm rotor

Posts: 4826

Joined: Mon Oct 03, 2011 4:19 pm

Location: Spirit Lake, ID

Website

Top

Re: florida newbee

by CumminsPower59 » Thu May 16, 2013 12:31 pm

Welcome!

Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed

CumminsPower59

14mm rotor

Posts: 3203

Joined: Mon Feb 25, 2008 8:04 am

Location: The Hawkeye State of 'Murica!

Top