hope I haven't posted too much
Michael
Washington 1st gen
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
Washington 1st gen
by 1grumpy » Tue Jul 16, 2013 1:10 am
been on here awhile ago and done forgot my username oh well lol. Let's see I have a 93 2wd 350 dually auto with 186k on it.It has a hx35/40 hybrid turbo, 3600 gov spring, ddp fuel pin, gauges are pyro/boost/trans temp. I use the truck too pull my 96 2dr xj around. the jeep is sitting on a dana60 in frt and a HD70 w/disc's both dually axles. its a 5spd with a crawlbox then a dana300 my crawl ratio is 200 to 1 I6 is the engine but would like to put a 4cyl cummins with nv4500 trans.
hope I haven't posted too much
Michael
hope I haven't posted too much
Michael
- 1grumpy
- smoke screw?
- Posts: 4
- Joined: Sat Jul 13, 2013 5:12 pm
Re: Washington 1st gen
by RCCUMMINS89 » Tue Jul 16, 2013 5:20 pm
Welcome.............where at in Washington?
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
- RCCUMMINS89
- 14mm rotor
- Posts: 4826
- Joined: Mon Oct 03, 2011 4:19 pm
- Location: Spirit Lake, ID