1stGen.org • View topic - Need Help!!

Need Help!!

Moderators: Greenleaf, BC847, Richie O

6 posts • Page 1 of 1

Need Help!!

by *Sweet Nothin* » Fri Nov 08, 2013 8:02 pm

Wondering how to turn my pump up on my 1993 Dodge 350?? Please respond with answers on how to.....

*Sweet Nothin*: smoke screw?; Posts: 3; Joined: Fri Nov 08, 2013 7:48 pm

Re: Need Help!!

by ellis93 » Sat Nov 09, 2013 4:40 am

Welcome,look here viewtopic.php?f=45&t=10060

93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz

ellis93: 14mm rotor; Posts: 7761; Joined: Wed Feb 17, 2010 3:16 pm; Location: lucedale,mississippi

Re: Need Help!!

by RCCUMMINS89 » Sat Nov 09, 2013 7:59 am

Welcome

89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.

RCCUMMINS89

14mm rotor

Posts: 4826

Joined: Mon Oct 03, 2011 4:19 pm

Location: Spirit Lake, ID

Website

Re: Need Help!!

by CumminsPower59 » Sat Nov 09, 2013 9:11 pm

Welcome!

Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed

CumminsPower59

14mm rotor

Posts: 3203

Joined: Mon Feb 25, 2008 8:04 am

Location: The Hawkeye State of 'Murica!

YIM

Re: Need Help!!

by dazedandconfused » Sun Nov 10, 2013 12:47 pm

http://dodgeram.org/tech/dsl/more_power/Power_ve.htm

Big Andy
1983 Dodge D150 that has been repowered with a 93 Cummins/518 running gear AKA The Ugly Duck! I would much rather build them then buy them.[

dazedandconfused: 14mm rotor; Posts: 6119; Joined: Thu Apr 05, 2007 6:25 pm; Location: Walton, Kentucky

Re: Need Help!!

by *Sweet Nothin* » Mon Nov 11, 2013 7:19 pm

Thanks everyone for the help!!!!!!!!

*Sweet Nothin*: smoke screw?; Posts: 3; Joined: Fri Nov 08, 2013 7:48 pm

6 posts • Page 1 of 1

Return to Welcome

Jump to:

Who is online

Users browsing this forum: No registered users and 11 guests