new guy on the block

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

new guy on the block

Postby smokintwins25 » Fri Jul 25, 2014 12:28 am

hello im new on here so I figure I tell yea little about my truck and interduce myself if that's fine my truck a 91.5 1 ton auto 3.54 gears my engine mods are a 12mm ve 3800 gsk stg2 fuel pin locktight pump seal 22psi pressure custom built 2 holley blue fuel pump and fass regulator hot screw 22 to 25 on timing non ic dv"s 5x20 injectors sdj built holset hx52 67/71/11 custom built dual intake mainifold and stock ported exhaust manifold stk 518A tranny looking to swap a 47rh in it this winter
smokintwins25
smoke screw?
 
Posts: 3
Joined: Thu Jul 24, 2014 11:06 pm

Re: new guy on the block

Postby RCCUMMINS89 » Fri Jul 25, 2014 8:25 pm

Welcome... you have an 11 cm housing on that 52?
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID

Re: new guy on the block

Postby oldestof11 » Sat Jul 26, 2014 4:26 am

Welcome!
Jon
93 D250~ Mismatch of cheap parts, trying to look fast going slow
User avatar
oldestof11
14mm rotor
 
Posts: 4147
Joined: Tue Apr 24, 2007 4:46 pm
Location: Northern Illinois
Top

Re: new guy on the block

Postby 93flatbed » Sun Jul 27, 2014 1:55 pm

Welcome to the group of misfits.

I'm interested in that 11 housing too. I ran an 16cm HX52 as a single for a while. Loved that thing when it came to life. At the time I didn't have nearly the injector you did either. Bet that's a fun set-up you have.
93 W250. Waiting on EFI live to come out with a ve version.
93flatbed
fuel screw!!!!
 
Posts: 198
Joined: Mon Apr 13, 2009 7:51 pm
Location: Buckeye AZ
Top


Return to Welcome

Who is online

Users browsing this forum: No registered users and 7 guests