New from BC

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

New from BC

Postby whiskeybravo » Sat Oct 04, 2014 8:06 pm

Hi , I had my 93 W250 LE club now for 6 months.
I'll never own a gaspot truck again.
whiskeybravo
smoke screw?
 
Posts: 1
Joined: Sat Oct 04, 2014 7:59 pm

Re: New from BC

Postby CumminsPower59 » Sun Oct 05, 2014 3:49 am

Welcome!
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!

Re: New from BC

Postby ellis93 » Sun Oct 05, 2014 5:36 am

Welcome!
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7761
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi
Top

Re: New from BC

Postby RCCUMMINS89 » Sun Oct 05, 2014 3:12 pm

Welcome
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Re: New from BC

Postby thrashingcows » Mon Oct 06, 2014 11:00 pm

whiskeybravo wrote:Hi , I had my 93 W250 LE club now for 6 months.
I'll never own a gaspot truck again.


I felt the same way after buying my cummins crewcab 4 years ago. Bit of a steep learning curve...but worth it!

Congrats on the new truck. I'm a BC 1st Gen'er as well...where you at?
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 575
Joined: Wed Nov 02, 2011 12:00 am
Top

Re: New from BC

Postby jay » Tue Oct 07, 2014 12:42 pm

Welcome
92 D350 CC bd diesel fuel pin and governor spring timing advanced 6 degrees power screw turned.Had a 93 D250 CC denny t fuel pin 3200 governor spring timing advanced 6 degrees power screw done 100 hp DSS injectors he 351 turbo dual disc clutch
jay
fuel pin?
 
Posts: 9
Joined: Sun Oct 05, 2014 4:19 pm
Location: Blackfalds Alberta
Top

Re: New from BC

Postby DMan1198 » Tue Oct 07, 2014 10:40 pm

Welcome
Ducati- professional nap taker, and thread derailer extraordinaire
Brownie: 80 dodge heavy half. Ghost cummins under the hood, and some sinister plans
The Roo Hunter: 93 w250, lifted, 2 whistle machines, and a bunch of other go fast goodies, uhh..... not there yet
Jaeger: 12 ram 3500. Lifted, exhausted, and fed an excessive quantity of air
The Huntress: 02 Jetta TDI. No muffler, egr, horsepower
DMan1198
14mm rotor
 
Posts: 2254
Joined: Sat Aug 10, 2013 6:26 am
Location: Slave Lake, Alberta
Top


Return to Welcome

Who is online

Users browsing this forum: No registered users and 7 guests