New Member- Compound Turbo First Gen- Iowa

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

Re: New Member- Compound Turbo First Gen- Iowa

Postby ellis93 » Sat Feb 07, 2015 6:07 am

Ike check out the junker drag truck tread on compd,he found a tool to do it to the block,with it in the truck.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7761
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi

Re: New Member- Compound Turbo First Gen- Iowa

Postby PToombs » Sat Feb 07, 2015 10:48 am

My buddy with the machine shop and I looked into getting the stuff to do O-rings. It was crazy, about $7-800 for the plate, then the tool and bits was on top of that. We decided to just take to somebody he knew and get it done.

Ike, I have a place, but I bet shipping will be more than the job! :lol:
pete

Just enough power to break everything behind the crankshaft.
User avatar
PToombs
14mm rotor
 
Posts: 11367
Joined: Sun Jan 07, 2007 6:13 pm
Location: Syracuse NY. Snow central!

Previous

Return to Welcome

Who is online

Users browsing this forum: No registered users and 8 guests