1stGen.org

THE place for 1st gens

Skip to content

so, starting off

Stop in and say hi

Moderators: Greenleaf, BC847, Richie O

Post a reply

so, starting off

Postby brewer » Wed Mar 18, 2015 6:07 pm

On this forum. Have owned a 2nd gen for 9 years and own a 1st now too. I've had it for about 2 years.

It's a '92 D250, stock. 5 speed, reg. cabw/ Callen camper.

I love it. Recently the odometer went out, at 189,313. I came here to see if I can find info on how to fix it.
brewer
fuel pin?
 
Posts: 5
Joined: Wed Mar 18, 2015 5:23 pm
Top

Re: so, starting off

Postby RCCUMMINS89 » Wed Mar 18, 2015 10:03 pm

Welcome, post up a thread.
89 RC on shortened 92 diesel frame - NV4500 w/dual disc/4.10s on 37s. - Self built pump, "hot screw", lots of timing, True high volume low pressure lift pump, 62fmw/68/.7gated, 77lpm SAC Inj., Studs/O-rings,- 423/1220 Mustang - 11/16/2013 http://www.TheHungryDiesel.com full line dealer, if you don't see it please ask.
RCCUMMINS89
14mm rotor
 
Posts: 4826
Joined: Mon Oct 03, 2011 4:19 pm
Location: Spirit Lake, ID
Top

Re: so, starting off

Postby CumminsPower59 » Thu Mar 19, 2015 4:00 am

Welcome!

Most of the odometer failures are because of broken gears, they are small and the plastic becomes brittle with age. There is a company that makes the gears, for about $20.
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!
Top

Re: so, starting off

Postby thrashingcows » Thu Mar 19, 2015 11:08 am

Or perhaps the VSS crapped out?
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 575
Joined: Wed Nov 02, 2011 12:00 am
Top

Re: so, starting off

Postby brewer » Sun Mar 22, 2015 6:56 pm

What is the VSS?
brewer
fuel pin?
 
Posts: 5
Joined: Wed Mar 18, 2015 5:23 pm
Top

Re: so, starting off

Postby CumminsPower59 » Sun Mar 22, 2015 7:16 pm

Vehicle Speed Sensor. If you have a functioning speedometer but no odometer, it isn't the issue. 95% of the time, its the gears in the speedometer/odometer assembly.
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!
Top
Post a reply

Return to Welcome

Who is online

Users browsing this forum: No registered users and 14 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group