Upper control arm

everything but the drivetrain

Moderators: Greenleaf, BC847, Richie O

Upper control arm

Postby meby » Tue Feb 13, 2018 5:45 pm

Does anyone know if the inner bolts by the frame are supposed to drop right in the bushings? My bolts are slightly bigger than the new Moog bushings. Didn't measure, but they are off by only a couple thousands.

Can I freeze the bolts and warm the bushings or should I drill out the bushings?
-1991 D-250 bone stock
-2000 Ford Windstar TDI Diesel 5 spd
-1997 Civic Hatchback
-Case 530 CK
-Old Huskee Garden Tractor w/Cub Cadet deck, Simplicity Snow-blower, loaded tires & chains - is it weird the tractor is modded more than my truck?
-Speedex Walking Tractor.
-BCS Walking Tractor


www.ebyfarmsllc.com
User avatar
meby
14mm rotor
 
Posts: 853
Joined: Sun Jan 14, 2007 1:14 pm
Location: Southwest Michigan

Re: Upper control arm

Postby thrashingcows » Tue Feb 13, 2018 7:35 pm

They need to spin inside the bushing so you can adjust the A-arms when doing alignments. Mopar used that same style of bushing on many different makes and models over the years. I'm guessing you got the wrong ones.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 554
Joined: Wed Nov 02, 2011 12:00 am


Return to Chassis

Who is online

Users browsing this forum: No registered users and 2 guests