Dana 70 speedy sleeve? Leaking seal again...

everything but the drivetrain

Moderators: Greenleaf, BC847, Richie O

Re: Dana 70 speedy sleeve? Leaking seal again...

Postby CumminsPower59 » Fri Feb 07, 2014 11:03 am

I don't mess with re use of the nylon lock nut, I swap it out with nuts that go on the front axle (D60). Works very well ;)

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
14mm rotor
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!

Re: Dana 70 speedy sleeve? Leaking seal again...

Postby 762frmafr » Tue May 26, 2015 12:14 pm

Does anyone have the Part numbers for the Speedi Seal and 2 piece seal for the Dually spindles? After researching the part numbers in this post, I don't believe they will work. The part number I get from the parts store for my wheel seal is 455086 National Oil Seal.
fuel screw!!!!
Posts: 177
Joined: Thu Sep 12, 2013 12:53 pm

Re: Dana 70 speedy sleeve? Leaking seal again...

Postby little doug » Sun Jun 21, 2015 5:07 pm

You are right . I have learned the seal and wear sleave #s I posted are wrong ...too small .
The sleeve should be somewhere in the range on page 7 of this link. I haven't looked in depth yet... If you google the part # starting 99*** SKF you can get price and dimentions from Amazon.
http://www.skf.com/group/products/seals ... index.html
2000 W3500 6 speed quad cab...Round truck
93 W250 LE extra cab, 5 speed,warn winch, tach,piro,boost guages. 1 turn on power screw... Play truck
-91 W350 LE reg cab chassis.exxxxtended 175"wb, banks intercooler,on board air ,5 speed,... Work truck
little doug
fuel screw!!!!
Posts: 79
Joined: Fri Nov 12, 2010 11:08 am
Location: Genesee Id.

Re: Dana 70 speedy sleeve? Leaking seal again...

Postby Moebiusgold » Tue Dec 13, 2016 7:43 pm

The DRW repair sleeve is SKF 99287. Can't seem to come up with the trick axle seal number though
92 W350 DRW
fuel pin?
Posts: 14
Joined: Sat Oct 10, 2009 10:22 pm
Location: Oregon


Return to Chassis

Who is online

Users browsing this forum: No registered users and 2 guests