Piping 4 in exhaust

everything but the drivetrain

Moderators: Greenleaf, BC847, Richie O

Piping 4 in exhaust

Postby 92cummins89 » Sun Jun 29, 2014 1:58 pm

Finally have everything in trans, tease, front and rear drive shafts now time for the exhaust. I went with4 inch diamond eye have a quick question.... There is a cross member piece tht holds the trans and tcase up and two braces one on driver side one on passenger side my exhaust will not fit In between there do u just remove this brace and b done or is there another way thanks
1992 4x4, 4” diamond eye exhaust, nv4500, he351cw
92cummins89
fuel screw!!!!
 
Posts: 179
Joined: Sat Sep 14, 2013 8:46 pm

Re: Piping 4 in exhaust

Postby CumminsPower59 » Sun Jun 29, 2014 2:12 pm

It'll fit...it's just real tight. On my 91, there is about 1/4" all around. You may have to flip how you are putting that piece in, takes a little English to get it through there and not hit anything when the clamps are all tightened. BTW, I hope you aren't using those gawd awful u bolt clamps, flat band clamps are the way to go. You won't have a huge fight if you have to remove the exhaust for some reason.
Ike

91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
CumminsPower59
14mm rotor
 
Posts: 3203
Joined: Mon Feb 25, 2008 8:04 am
Location: The Hawkeye State of 'Murica!

Re: Piping 4 in exhaust

Postby Tacoclaw » Sun Jun 29, 2014 7:55 pm

I know I didn't bother, I took it out of there. You can't get the top three bolts out of the frame as they'll hit the body, but they don't hurt anything.
1990 W250 4x4
Rattles, growls, whistles, and whines.
User avatar
Tacoclaw
14mm rotor
 
Posts: 4108
Joined: Wed Mar 11, 2009 7:50 am
Location: Cheshire, OH
Top

Re: Piping 4 in exhaust

Postby 92cummins89 » Sun Jun 29, 2014 8:06 pm

I managed to get it in there with the cross member there just a little tight
1992 4x4, 4” diamond eye exhaust, nv4500, he351cw
92cummins89
fuel screw!!!!
 
Posts: 179
Joined: Sat Sep 14, 2013 8:46 pm
Top

Re: Piping 4 in exhaust

Postby 92cummins89 » Sun Jun 29, 2014 8:13 pm

I managed to get it in there with the cross member there just a little tight
1992 4x4, 4” diamond eye exhaust, nv4500, he351cw
92cummins89
fuel screw!!!!
 
Posts: 179
Joined: Sat Sep 14, 2013 8:46 pm
Top


Return to Chassis

Who is online

Users browsing this forum: No registered users and 6 guests

cron