I think I need some new wheel bearings when I replace my wheel seals on my rear 70. Somebody overtorqued the nuts at one point...
Question is: can I tap them out of the hub or I have to use a press?
Dana 70 Wheel Bearing Replacement - Press Needed?
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
Dana 70 Wheel Bearing Replacement - Press Needed?
by Diesel » Thu Jul 24, 2014 10:48 am
1991.5 D250 Intercooled A518
- Diesel
- 14mm rotor
- Posts: 839
- Joined: Wed May 25, 2011 8:13 pm
Re: Dana 70 Wheel Bearing Replacement - Press Needed?
by Black93 » Thu Jul 24, 2014 11:20 am
The wheel bearings are loose, knock the races out with a long punch.
1993 W350 LE ext. cab dually, tuned pump, 60mm HX35, NV4500, 4" straight tbe, 366, 1/8" bump, THD fuel pin & lppp, DPS manifold, DFI 5x12's, 3" tubes, PS IC, D80 rear, 3.54's, 4th gen Alcoas.
-
Black93 - fuel screw!!!!
- Posts: 231
- Joined: Mon Aug 17, 2009 10:33 am
- Location: TN