W250 front brakes
Moderators: Greenleaf, BC847, Richie O
3 posts
• Page 1 of 1
W250 front brakes
by Makaio » Mon Sep 29, 2008 11:12 pm
How are our front brakes set up? Are the rotors and hubs separate or one unit? Looking through the port hole in the rim, the pads are well worn and wearing into the rotor. The guy at NAPA had two listings but didn't know which one to sell/quote me.
Matt
1992 W250 auto, ASA/AFE intake, H1C hybrid 60-16, Bosch 190's, Bully Dog fuel pin, 366 spring, modified pump and a 4" turbo back exhaust. Suncoast valve body plumbing 3.54's w/LSD. Autometer gauges.
1992 W250 auto, ASA/AFE intake, H1C hybrid 60-16, Bosch 190's, Bully Dog fuel pin, 366 spring, modified pump and a 4" turbo back exhaust. Suncoast valve body plumbing 3.54's w/LSD. Autometer gauges.
-
Makaio - fuel screw!!!!
- Posts: 47
- Joined: Wed Sep 05, 2007 9:39 pm
- Location: Waiahole, Hawaii (island of Oahu)
by oldestof11 » Tue Sep 30, 2008 1:28 pm
Get the 4500lbs front axle rotors.
The rotors are a PITA to change out. You need to take the hub off and tap out the studs. I would put the lug nuts back on until the end of the stud is flush with the top of the nut, put a block of wood on it, and tap it out with a sledge hammer.....
The rotors are a PITA to change out. You need to take the hub off and tap out the studs. I would put the lug nuts back on until the end of the stud is flush with the top of the nut, put a block of wood on it, and tap it out with a sledge hammer.....
Jon
93 D250~ Mismatch of cheap parts, trying to look fast going slow
93 D250~ Mismatch of cheap parts, trying to look fast going slow
-
oldestof11 - 14mm rotor
- Posts: 4147
- Joined: Tue Apr 24, 2007 4:46 pm
- Location: Northern Illinois
