Anyways was wonderin what tools work good for upper @ lower ball joints.Got 4 Dymax? balljoints to put in.I know I will need a spring compressor.Never done ball joints before,any opinions @ input appreciated,thanks. 
Shocks @ balljoints
Moderators: Greenleaf, BC847, Richie O
1 post
• Page 1 of 1
Shocks @ balljoints
by Remps » Wed Jun 24, 2009 9:12 pm
Just put new front shocks on today,Monroe gas magnums,night @ day difference between the blown ones. Anyways was wonderin what tools work good for upper @ lower ball joints.Got 4 Dymax? balljoints to put in.I know I will need a spring compressor.Never done ball joints before,any opinions @ input appreciated,thanks.
Anyways was wonderin what tools work good for upper @ lower ball joints.Got 4 Dymax? balljoints to put in.I know I will need a spring compressor.Never done ball joints before,any opinions @ input appreciated,thanks. '90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
-
Remps - 14mm rotor
- Posts: 1130
- Joined: Sun May 03, 2009 12:57 am
- Location: Saskatchewan
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 35 guests