Moderators: Greenleaf, BC847, Richie O
93oneton wrote:,thanks jimmied, i have also read about that bypass valve in the exhaust flap. I was goin to try and regulate the air pressure goin to my actuator so if it got to around 55-60 lbs it would open and keep the pressure in the safe zone. Not sure if it will work yet but i will be doin some testing on it before i install it this spring
swank wrote:93oneton wrote:,thanks jimmied, i have also read about that bypass valve in the exhaust flap. I was goin to try and regulate the air pressure goin to my actuator so if it got to around 55-60 lbs it would open and keep the pressure in the safe zone. Not sure if it will work yet but i will be doin some testing on it before i install it this spring
That is my plan for attacking this problem as well. I've got one of these sitting around that I built a long time ago. Haven't installed it though. My plan was just to install a bleeder valve or regulator somewhere in the line and mount a temporary gauge to the exhaust, get everything adjusted while idling, then seal it up.
Ryker Carruthers wrote:What are the specs on the air cylinder you have?
Return to Cool projects YOU can do
Users browsing this forum: No registered users and 21 guests