SpeediSLeeve and other #s for Getrags

Moderators: Greenleaf, BC847, Richie O

SpeediSLeeve and other #s for Getrags

Postby dpuckett » Wed Mar 28, 2007 4:21 pm

I know this is likely not too hot a topic, but I had occasion to need the input seal surface cleaned up (brand new- came in the toolbox of one of my ElCheapo Texas trucks, and had appreciable rust) and bead blasting didnt get it like I wanted, so I went to NAPA and inquired about a speedi-sleeve for it. They had one. Part number is Chicago Rawhide #99166. It was $28 and some change with my discount (g/f works at one of their leading shops as far as sales volume), but it beat a new input shaft at $100-150 and that is last fall's prices.

I also have a number floating around for the little boot that goes on top of the shift tower (NOT either of the ones inside the cab floor, but actually clamps to the tranny). It is a CV boot that requires 2 new worm type clamps, but I have installed 4 of them with good results.

Daniel
His- 93 W250 club cab LE, auto to Getrag conversion, piston lift pump, 3.54 LSD. 400k+
Hers- 04 QC 4x4. Built auto, Triple Dog, Air Dog. Funny Round truck that aint so quiet.
dpuckett
14mm rotor
 
Posts: 2196
Joined: Wed Jan 03, 2007 4:33 pm
Location: Perryville MO

Return to Part numbers (old,new,cross reference)

Who is online

Users browsing this forum: No registered users and 10 guests

cron