sled pull/dyno events?

Sled-pulling, Drag results, Dyno results

Moderators: Greenleaf, KTA, BC847, Richie O

sled pull/dyno events?

Postby Hansen01 » Thu Jun 09, 2011 11:42 am

anybody here have a list of dates for upcoming sled pull/ dyno events in nebraska?
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE

Re: sled pull/dyno events?

Postby Richie O » Thu Jun 09, 2011 1:07 pm

Hansen01 wrote:anybody here have a list of dates for upcoming sled pull/ dyno events in nebraska?


Andrew ( pulltilbroke ) would have a good link, but I think he is headed to Iowa for the weekend. He is from the eastern side of Nebraska. He pulls alot during the summer.
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
User avatar
Richie O
Administrator
 
Posts: 4114
Joined: Sat May 17, 2008 9:01 pm
Location: New England

Re: sled pull/dyno events?

Postby Hansen01 » Thu Jun 09, 2011 4:12 pm

hmm ok thanks hes bound to chime in sometime
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE
Top

Re: sled pull/dyno events?

Postby pulltilbroke » Thu Jun 09, 2011 7:04 pm

Heres a thread for all known pulls Organized and not.

http://www.cumminsforum.com/forum/nebra ... l-fun.html



BTW where ya located??
90 W250 reg cab, Modified knuder valve, reversed reciprocting dinglearm adjusted, High volume flux capacitor,upgraded whirlygig, A clutch and a hitch
93 W350 ext cab dually, getrag and a few adjustments
pulltilbroke
14mm rotor
 
Posts: 1410
Joined: Fri Jan 18, 2008 1:20 am
Location: Eagle Ne
Top

Re: sled pull/dyno events?

Postby Hansen01 » Thu Jun 09, 2011 9:48 pm

thanks for that, from Tekamah Nebraska, just trying to find a couple more pulls half ways close, other than missouri valley and arlington to go to, :D
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE
Top


Return to Competition

Who is online

Users browsing this forum: No registered users and 2 guests