9.18 80mph 1/8th

Sled-pulling, Drag results, Dyno results

Moderators: Greenleaf, KTA, BC847, Richie O

9.18 80mph 1/8th

Postby bgilbert » Fri Jul 18, 2008 7:39 pm

New time, 9.1839 @ 80.62mph street tires of course and on a 'fun night' where there's no vht or whatever it's called :roll: .

RT .1560
60ft 2.2819
330 6.1270
594 8.6240
1/8 9.1839 80.62mph

Put the bulkhead fitting in the bottom of the tank, and bumped the timing some. Slicks, maybe some tranny work and a slightly smaller turbo and I might be doing something. Was fun, made about 5 passes, everything is still intact :D !
Bill Gilbert
85 D350 crew with 90 6BT intercooled Getrag 3.07's
93 D350 single cab Getrag 3.54's.
bgilbert
14mm rotor
 
Posts: 2253
Joined: Wed Jan 03, 2007 5:04 pm
Location: Terre Haute, Indiana

Postby oldcool90 » Fri Jul 18, 2008 8:10 pm

Tell them about your first pass 80psi in rear tires :lol: :lol: :lol: :oops: :oops: :lol: :lol: :lol:
1992 reg cab W-350 5sp 12cm ex housing,pod's,3200rpm gov,and piston lift pump
oldcool90
fuel screw!!!!
 
Posts: 164
Joined: Sun Jun 03, 2007 1:50 pm
Location: terre haute In.

Postby bgilbert » Fri Jul 18, 2008 8:13 pm

oldcool90 wrote:Tell them about your first pass 80psi in rear tires :lol: :lol: :lol: :oops: :oops: :lol: :lol: :lol:

Yeah yeah, that wasn't fun. Spun tires, spun tires, then almost met the wall at 50mph :shock: :shock: , no good! Rolled back to the pits and ran them down from 80psi to 30psi, then did the 9.18 8) .
bgilbert
14mm rotor
 
Posts: 2253
Joined: Wed Jan 03, 2007 5:04 pm
Location: Terre Haute, Indiana
Top

Postby Philip » Sat Jul 19, 2008 6:05 am

Yeah yeah, that wasn't fun. Spun tires, spun tires, then almost met the wall at 50mph


But you know the crowd loved it. :lol:
93 W350 Club/cab w/duals, buckets & console, B&W flatbed, G56, 6 spd, 3:07 rears, gages, HX40/16, 4" exhaust, 6X.018 sticks, rear air ride suspension
User avatar
Philip
14mm rotor
 
Posts: 1954
Joined: Mon Jan 08, 2007 10:50 am
Location: Indiana
Top

Postby PToombs » Sun Jul 20, 2008 6:49 am

Video! Video! :D

Oh, good times too. ;)
pete

Just enough power to break everything behind the crankshaft.
User avatar
PToombs
14mm rotor
 
Posts: 11367
Joined: Sun Jan 07, 2007 6:13 pm
Location: Syracuse NY. Snow central!
Top


Return to Competition

Who is online

Users browsing this forum: No registered users and 11 guests