Ratio adapter

How they work, how they don't work, and how to fix them

Moderators: Greenleaf, BC847, Richie O

Ratio adapter

Postby Jelmer » Wed Feb 14, 2018 12:59 am

Our 93 didn't come with a ratio adapter on it when we got it so the speedo is way off.
We ordered a ratio adapter from the Transmission centre but it doesn't fit because the crossmember is in the way.

This is how it looks:

Image

But I think it should look like this one:

Image

Can I turn one of the lids on the ratio adapter so that it is an offset piece and will it clear the crossmember like this?
Truck is 100% stock transmission wise.
Greetings from the Netherlands where there are only 2 or 3 1stgens!
93 D250 Cummins, G360, 4" stainless exhaust, BHAF, DennyT stage 2 pin, 3200rpm governor spring, 12cm housing, rest stock.
03 VW Bora 1.6
83 Datsun Laurel 4.5 32v V8
84 Nissan Patrol 2.8i
Jelmer
fuel screw!!!!
 
Posts: 48
Joined: Thu Jan 15, 2009 7:40 pm
Location: Netherlands

Re: Ratio adapter

Postby thrashingcows » Wed Feb 14, 2018 8:46 pm

I have never had one apart so can not say if there is a different orientation on the gearing inside if the top is switch positions. But worth a try since shipping on another piece is probably costly. ;)
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 538
Joined: Wed Nov 02, 2011 12:00 am


Return to Transmission

Who is online

Users browsing this forum: No registered users and 2 guests