Need help securing lockdown cable to trans

How they work, how they don't work, and how to fix them

Moderators: Greenleaf, BC847, Richie O

Need help securing lockdown cable to trans

Postby Collers9640 » Mon May 13, 2019 8:24 am

Does anyone have a remedy for securing the kick down cable to the ball stud on the transmission. The white plastic piece that snaps on the ball stud is apparently worn out enough to cause it to pop off
77’ W200 Cummins- Auto, BHAF, 4” Exhaust
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
Collers9640
fuel screw!!!!
 
Posts: 168
Joined: Wed Feb 24, 2010 4:25 pm
Location: Charleston SC

Re: Need help securing lockdown cable to trans

Postby thrashingcows » Thu May 16, 2019 6:22 pm

A couple of Zip ties is all I can think of.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 576
Joined: Wed Nov 02, 2011 12:00 am

Re: Need help securing lockdown cable to trans

Postby Collers9640 » Sat May 18, 2019 8:53 am

I don’t think zip ties are gonna work. Hmmmm I can’t believe no one else has had this problem
77’ W200 Cummins- Auto, BHAF, 4” Exhaust
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
Collers9640
fuel screw!!!!
 
Posts: 168
Joined: Wed Feb 24, 2010 4:25 pm
Location: Charleston SC
Top

Re: Need help securing lockdown cable to trans

Postby PToombs » Mon May 20, 2019 4:49 pm

Try a solder gun to melt the edges and push them in to tighten the hole. If you need filler, a white zip tie might work.
pete

Just enough power to break everything behind the crankshaft.
User avatar
PToombs
14mm rotor
 
Posts: 11281
Joined: Sun Jan 07, 2007 6:13 pm
Location: Syracuse NY. Snow central!
Top


Return to Transmission

Who is online

Users browsing this forum: No registered users and 1 guest