I was working on my np205 rebuild and was putting on the output shaft bearing, it went on fine but when I went to put the snap ring on it would snap in. Then I discovered the inner race in about .026 thousandths to wide.
I purchased the kit from a company on ebay. The box the bearing came in was Quest made in japan. Has anyone else done a rebuilt and had this problem with these bearings?
Np205 bearing to wide???
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
Np205 bearing to wide???
by Collers9640 » Thu Aug 07, 2014 9:00 am
77’ W200 Cummins- Auto, BHAF, 4” Exhaust
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
91.5 W250 Cummins Conversion- PS I/C, pump maxed, Red Oak Diesel Injectors, Coolertubz, pump advanced 1/8", 3" elbow, 3200 Spring, Piston Lift Pump, KDP fixed, DennyT pin, HX35, 4in Downpipe, BHAF, Heater Grid Delete, Alcan springs, Bilstein Shocks
1984 D350 Crew Cab (Future Cummins Project)
- Collers9640
- fuel screw!!!!
- Posts: 171
- Joined: Wed Feb 24, 2010 4:25 pm
- Location: Charleston SC
Re: Np205 bearing to wide???
by simplysmn » Wed Aug 13, 2014 11:02 pm
sound's like they sent you the 5 sp bearing maybe ? I would contact them when I ordered my kit .I called and told them what truck it was for to make sure I got the right bearing's .
- simplysmn
- fuel screw!!!!
- Posts: 250
- Joined: Thu May 17, 2012 10:24 pm
- Location: Southern Ca