Front driveshaft
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
Front driveshaft
by Remps » Wed Jun 03, 2015 10:10 pm
Does anybody sell replacement front driveshafts, or are they junkyard only nowadays?
'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
-
Remps - 14mm rotor
- Posts: 1128
- Joined: Sun May 03, 2009 12:57 am
- Location: Saskatchewan
Re: Front driveshaft
by Philip » Fri Jun 05, 2015 7:58 pm
NAPA sells a replacement.
But It has a smaller front u-joint than your stocker. It uses an adapter type u-joint. The caps for the axle yoke are bigger than the drive shaft caps are.
A friend of mine got one a few years ago. After about a month he ripped that smaller u-joint out.
But It has a smaller front u-joint than your stocker. It uses an adapter type u-joint. The caps for the axle yoke are bigger than the drive shaft caps are.
A friend of mine got one a few years ago. After about a month he ripped that smaller u-joint out.
93 W350 Club/cab w/duals, buckets & console, B&W flatbed, G56, 6 spd, 3:07 rears, gages, HX40/16, 4" exhaust, 6X.018 sticks, rear air ride suspension
-
Philip - 14mm rotor
- Posts: 1954
- Joined: Mon Jan 08, 2007 10:50 am
- Location: Indiana