48re anyone do this swap
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
48re anyone do this swap
by nova6511 » Sun Jul 16, 2017 5:28 pm
I bought an already built 04 48re with billet convertor already done. Has anyone here done a 48 swap, found plenty of 47 swaps. The transmission should be the same other then the valve body is that correct.
- nova6511
- fuel screw!!!!
- Posts: 49
- Joined: Wed Jul 20, 2011 5:12 pm
Re: 48re anyone do this swap
by Remps » Sun Jul 16, 2017 10:04 pm
Pretty sure there are more differences than just the valve body, although no specifics are coming to mind. 
It would have to be converted to hydraulic control somehow (probably a pita) or used with a standalone controller. I think there is a few controllers out there. Firepunk has a complete 48re swap for the new 6.7.
It would have to be converted to hydraulic control somehow (probably a pita) or used with a standalone controller. I think there is a few controllers out there. Firepunk has a complete 48re swap for the new 6.7.'90 D250 R/C,727,IC,6x.009's,1/8" bump,fuel psi,straight pipe w/5" stack.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
'90 W250 R/C,47rh,K@N,HX35,1/8" bump,2nd gen IC,boost,egt,trans temp.3.07's.
'96 2500 S/C L/B,2wd,NV5600,3.54 L/S,cai,egt,pacbrake,mbrp exhaust,10 plate.
Bring back the Bank of Canada, PRE- 1974.
-
Remps - 14mm rotor
- Posts: 1130
- Joined: Sun May 03, 2009 12:57 am
- Location: Saskatchewan