Ignition switch ...maybe?

Does it have spark? And other questions...

Moderators: Greenleaf, BC847, Richie O

Ignition switch ...maybe?

Postby 92cummins89 » Thu Dec 13, 2018 10:05 pm

Do these trucks have an ignition switch?
When I turn the key on nothing comes on but if I jump the relay that is connected to the start b the truck turns in an runs but I have no gauges or lights or anything any ideas?
1992 4x4, 4” diamond eye exhaust, nv4500, he351cw
92cummins89
fuel screw!!!!
 
Posts: 179
Joined: Sat Sep 14, 2013 8:46 pm

Re: Ignition switch ...maybe?

Postby ellis93 » Fri Dec 14, 2018 5:08 pm

Check the fuse links on the driver finder,both visually and physically (pull on either end and make sure they done stretch)
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7747
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi

Re: Ignition switch ...maybe?

Postby thrashingcows » Fri Dec 14, 2018 5:16 pm

There is a starter relay on the drivers inner fender, one of the 3 small square black relays....not sure which one though. I would also check your fuse panel to ensure all of them are good....remove each one and check on a light.
But it does sound very fusable link related since you have no power at all to any of the circuits.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 573
Joined: Wed Nov 02, 2011 12:00 am
Top

Re: Ignition switch ...maybe?

Postby 92cummins89 » Fri Dec 14, 2018 6:29 pm

I deleted the fuseable links but I don’t have any lights, brakes turn or head lights
1992 4x4, 4” diamond eye exhaust, nv4500, he351cw
92cummins89
fuel screw!!!!
 
Posts: 179
Joined: Sat Sep 14, 2013 8:46 pm
Top


Return to Electrical

Who is online

Users browsing this forum: No registered users and 2 guests