check engine light- reading the codes?

Does it have spark? And other questions...

Moderators: Greenleaf, BC847, Richie O

check engine light- reading the codes?

Postby Hansen01 » Wed Jul 13, 2011 8:33 pm

ok so my dads abs and break light came on, so i turn the key off and on 3 times and it brings up code 55. anyone have a book for them? if not im sure its in that abs modual along the frame rail :?
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE

Re: check engine light- reading the codes?

Postby ellis93 » Thu Jul 14, 2011 3:58 am

93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
User avatar
ellis93
14mm rotor
 
Posts: 7762
Joined: Wed Feb 17, 2010 3:16 pm
Location: lucedale,mississippi

Re: check engine light- reading the codes?

Postby Hansen01 » Thu Jul 14, 2011 6:33 pm

exactly what i was looking for, thanks!! :D
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE
Top

Re: check engine light- reading the codes?

Postby Mark Nixon » Thu Jul 28, 2011 12:40 pm

55 is "end of codes".
To read the ABS module, the port for the scanner is usually located near the hood release cable.

Mark.
Mark Nixon
 
Top

Re: check engine light- reading the codes?

Postby Hansen01 » Thu Jul 28, 2011 4:15 pm

i figured it out after reading the link, but thanks mark, my brothers got a scanner, were gonna have to hook it up someday, i hate idiot lights, even when there not on my truck :? :D
1990 dodge W250 cummins 6 speed. 4in diamond eye, a turbo,and a pump :D
Under construction...
Hansen01
14mm rotor
 
Posts: 1125
Joined: Tue May 17, 2011 6:34 pm
Location: Tekamah NE
Top


Return to Electrical

Who is online

Users browsing this forum: No registered users and 22 guests