flasher power
Moderators: Greenleaf, BC847, Richie O
4 posts
• Page 1 of 1
flasher power
by skilletky » Wed Dec 26, 2012 2:09 pm
my flasher aint working. i got not power to the hazzard fuse. anyone know where the power supply wire to the hazzard fuse (pink wire with white tracer) gets it power from? i cant see the wire diagrams too well. i cant seem to find it. it looks like it goes to the fire wall harness. if i am right, then i got no power at the fire wall connector. does it get power from the pcm?
92 d350, arp's, orings, 150lb springs, 4200 gsk ,ground pin ,64/71/14 ,ddp inj's, ats manifold, tim's tubez, ats trans, FASS, locker, timing + a tooth, bcdd intake
2001 2wd rclb dually 5sp, smarty, Bluechip FMS, TS MVP, 57/75 twins, stainless diesel pipe kit, valair clutch, airdog 150, DFI SAC 7x.014's, cheap a$$ intake, ARP studs, oringed head, CPP 115# springs
2001 2wd rclb dually 5sp, smarty, Bluechip FMS, TS MVP, 57/75 twins, stainless diesel pipe kit, valair clutch, airdog 150, DFI SAC 7x.014's, cheap a$$ intake, ARP studs, oringed head, CPP 115# springs
-
skilletky - 14mm rotor
- Posts: 1070
- Joined: Thu Jan 10, 2008 5:49 pm
- Location: northern ky
Re: flasher power
by CumminsPower59 » Wed Dec 26, 2012 2:16 pm
The wire feeding the hazard fuze comes through the firewall connector at location #23.
It comes from its own fusible link, fed from a two prong connector that comes off the positive terminal on the battery, which the other wire goes to the starter...
Hope this helps ya, if not I can text you a clear, zoomed in picture of the diagram...
It comes from its own fusible link, fed from a two prong connector that comes off the positive terminal on the battery, which the other wire goes to the starter...
Hope this helps ya, if not I can text you a clear, zoomed in picture of the diagram...
Ike
91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
91 W350 SRW, 3.07's, NV4500, 370's, THD LPPP, Super HX40, 2nd gen IC swap, BHAF, Isspro's, 2" lift, 285's on 3rd gen 17"'s.
04 VW Jetta Wagon TDI 5speed
- CumminsPower59
- 14mm rotor
- Posts: 3203
- Joined: Mon Feb 25, 2008 8:04 am
- Location: The Hawkeye State of 'Murica!
