1stGen.org • View topic - fuel sender ohms

fuel sender ohms

Moderators: Greenleaf, BC847, Richie O

4 posts • Page 1 of 1

fuel sender ohms

by jb » Tue Jun 30, 2009 8:01 pm

I am replacing the fuel level gauge in the dash and was wondering if anyone has already figured out the ohms spec. for full/empty.

Thanks
JB

jb: fuel pin?; Posts: 10; Joined: Thu Sep 04, 2008 10:08 pm

by jb » Fri Jul 03, 2009 7:35 pm

anybody, anybody??????

thiers got to be somebody that has figured out the ohms range for a first gen truck.

jb: fuel pin?; Posts: 10; Joined: Thu Sep 04, 2008 10:08 pm

by Richie O » Fri Jul 03, 2009 8:20 pm

Not I, sorry.

1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k

Richie O: Administrator; Posts: 4171; Joined: Sat May 17, 2008 9:01 pm; Location: New England

by Begle1 » Sat Jul 04, 2009 3:41 pm

I figured it out, didn't bother to remember it though...

It was, like, not less than 10 and not more than 80?

1990 D-250 Regular Cab: Tweaked injection pump, built transmission, a cataclysmic charlie foxtrot of electronics, the most intense street-ran water injection system in the country, and some more unique stuff.

Begle1: 14mm rotor; Posts: 1964; Joined: Sat Jan 06, 2007 5:31 pm; Location: Kihei, Maui, Hawaii

4 posts • Page 1 of 1

Return to Electrical

Jump to:

Who is online

Users browsing this forum: No registered users and 37 guests