"Holes drilled in cab ceiling to combat roof rot"

both inside and out

Moderators: Greenleaf, BC847, Richie O

"Holes drilled in cab ceiling to combat roof rot"

Postby Begle1 » Sun Mar 31, 2019 1:28 pm

Anybody have pictures of holes drilled in their cab ceiling to combat roof rot/ rust from the inside out above the windshield?

I always hear it discussed as a "thing to do" but have never seen the end product.

If done clean then I imagine it'd be a good project.
1990 D-250 Regular Cab: Tweaked injection pump, built transmission, a cataclysmic charlie foxtrot of electronics, the most intense street-ran water injection system in the country, and some more unique stuff.
User avatar
Begle1
14mm rotor
 
Posts: 1919
Joined: Sat Jan 06, 2007 5:31 pm
Location: Capo Beach, California

Re: "Holes drilled in cab ceiling to combat roof rot"

Postby thrashingcows » Mon Apr 01, 2019 12:45 pm

The problem with the front header is there are 3 layers that come together and it's very prone to holing moisture. I personally use a long flexible extension sprayer for my Fluid-Film cans and then remove the visors and feed the sprayer in each side and give it a good coating.
1984/93 Dodge Crewcab, W350, 1 Ton SRW, long box, 330K Km's, M&H spacer, 366 spring, fuel pin to deep side, 14cm housing, Piston LP, PS IC, Isspro Boost, Pyro and tach, NV4500, 29 spline NP205, 3.54's.


Check out the build....http://www.dieseltruckresource.com/dev/ ... 05923.html
thrashingcows
14mm rotor
 
Posts: 575
Joined: Wed Nov 02, 2011 12:00 am


Return to Body

Who is online

Users browsing this forum: No registered users and 1 guest