Sagging Door
Moderators: Greenleaf, BC847, Richie O
5 posts
• Page 1 of 1
Sagging Door
by collegekid » Thu Jun 16, 2011 6:54 am
My drivers door sags quite a bit, I installed a pin and bushing kit, but it didnt fix the problem, as there another trick I could do, maybe put washers behind the three bolts on the bottom hinge?
1992 D350 CC LB 5-spd CTD, 366 GSK, Rotated Fuel Pin, Fuel Screw 1 turn off runaway, Factory Match Pyro and Boost, 4" Diamond eye exhaust, and a broken front sway bar 
http://photobucket.com/truckytruck
http://photobucket.com/truckytruck
- collegekid
- 14mm rotor
- Posts: 535
- Joined: Fri May 13, 2011 11:15 pm
Re: Sagging Door
by ellis93 » Thu Jun 16, 2011 8:01 am
I use body shims. Little easier to just slide them in.
93 D250 ,5 speed,4.11s,k&n autometer tach pyro trans boost guages,GDS 60mm h1c 14cm,honed 5x10,hplp/reg,1/8 timing,M+H M2 fuel pin, tims cooler tubz
-
ellis93 - 14mm rotor
- Posts: 7762
- Joined: Wed Feb 17, 2010 3:16 pm
- Location: lucedale,mississippi