Thanks
Edit: Got them on just took some skill
Do trim rings fit all models?
Moderators: Greenleaf, BC847, Richie O
2 posts
• Page 1 of 1
Do trim rings fit all models?
by 1990 » Wed Jun 29, 2011 1:03 pm
I picked up a set of trim ring from a 93 diesel. They just a bit too big too fit on my 1990. Or are they all like that?
Thanks
Edit: Got them on just took some skill
Thanks
Edit: Got them on just took some skill
Last edited by 1990 on Sun Jul 03, 2011 4:41 pm, edited 1 time in total.
-
1990 - fuel screw!!!!
- Posts: 341
- Joined: Thu Jun 10, 2010 12:51 pm
- Location: Alberta, Canada
Re: Do trim rings fit all models?
by Richie O » Wed Jun 29, 2011 3:36 pm
They all should be the same.
1989 W250 727, 3.07 L/S, S300, P/S Intercooler, Stans exaust, Pump adjustments, 127k miles,297 hp
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
1993 W250 extended cab, rag, 4.10 l/s, 6x16's, HTT 62/71/14 piston l/p, Isspro EV series tach, fuel pressure, boost, oil pres, water temp, volt, pryo, 132k/ 301 hp
1992 W250 with NV4500, 3.54's, 16cm 60mm GDS H1C, ground stock cone, Isspro tach, pryo, boost, fuel pressure, slow, rusty, dented,180k
-
Richie O - Administrator
- Posts: 4171
- Joined: Sat May 17, 2008 9:01 pm
- Location: New England