by TRENDZ » Sat Jan 07, 2012 10:08 am
I work for the dept of public works, we've been busy since fall, so I haven't had much time to do anything on the truck for a while. Here's a pic I have of the back side. I put a factory bumper on it. I used black chip gaurd on the top surface to give it a ritzy, modern look
. The tailgate trim is from an older truck, painted to match the bumper(O.K. it was really to hide the drill holes from the old emblems and hide the dents). The cummins emblem on it was chopped out of my old intake crossover tube. I finally put the side moldings on the box, yet haven't had time to install the steps in the bed gaps.
You do not have the required permissions to view the files attached to this post.
Last edited by
TRENDZ on Sat Jan 07, 2012 7:03 pm, edited 1 time in total.
91 d350 1/2" supply lines, 2nd gen lift pump, regulator, 366, screwed, homebrewed afc pin, linkage mods, ported head, ported ex manifold, 351ve electrically controlled, 3" boost tubes, 2nd gen I/C, 4" ex, goerand