Taillights

[ahale2772]

BTW I did get LED's for the taillights, they are bitchin cool

I love how fast the brake lights can cycle on and off

[ellis93]

Did they need the resistors?

[ahale2772]

I'm a woos, so I put them on

I may pull them out at some point to see if they work without, but my blinker flashes a bit faster with the led's in, so I bet they would screw it up more

[Tacoclaw]

Admittedly it's a little late now, but if you're having rust problems with those sockets why not just find a plastic or steel cup that fits over them and fill it with some grease .

Just a cut along it wide enough to fit the wires through, then slide it up to the back of the light and use a ziptie on the wires to hold it in place.


Also, just saw these over on CompD. Stainless: (n/m, the stainless ones aren't for STT. I'll leave that site up though, it's awesome and I've never seen it before.)

http://autolumination.com/connectors.htm

[remi]

the stack piping is a royal cluster FCUK its 4 inch past the t-case then it goes up and above the frame

essentially i just had to modify the death out of about 6 4inch 90's to get up and over the frame, then up to the bed. (i didnt want to cut a bed crossmember to get it thro)

I have to buy it flowers and dinner to get it out of the truck

Can you take a pic cause i have mine ran in front of the rossmember and it looks like sthi kinda so i wanna fix it haha

[ahale2772]

yeah, ill try to snap a pic, it was a PITA, id run it up throught the middle of the bed, then out to either side next time.

but yes ill try to snap one