visor

[CumminsPower59]

Mark,

I will have to take a look at those visors you have when I am out that way. One question, does it matter on them if the truck has clearance lights? Are they contured to form around them? Or do they sit far enough forward as to not interfere with them?

Thanks!

[Mark Nixon]

Ike, Lund made some with cutouts to clear the cab lights, which you could carefully cut in on any of them.
It's as simple as carefully marking and cutting them out.
I believe you only need to cut notches for the 2 outboards and the 1 center inboard, but I might be wrong, need to look.
Since I have one with the cutouts, it might not be too hard to make a template.

I have one of the cutout ones on the red/white flatbed that was at Michaels last year, if you saw that one.

Mark.

[CumminsPower59]

Currently, my 92 doesn't have clearance lights on it, but it will soon as I have the lights, wiring, etc to install. Marking and cutting wouldn't be too much work, as long as I have a reference to go off of. If I get one from ya, I will just match it up and mark it with a sharpie to get a rough in and fine tune it later on when I am ready to install it.

I did see that one on the flat bed when I was out there, and Andrew has a picture of it in one of his albums on "facehole"

[Mark Nixon]

If I could mark the cutouts on another visor by using the visor on the flatbed as a template, it could then be used to correctly mount your cab lights.
I'm assuming you're using the factory OEM cab lights?

Mark.

[CumminsPower59]

Correct. I have a guide sheet with measurements as to where to correctly place the lights. Since we are on the subject, where does the wiring for said lights plug in?

[Mark Nixon]

There's a female bullet connector that has a black wire with a yellow stripe that hangs off the headlamp switch.
It's kinda' located in the general area of the driver's side 'A' pillar.

Mark.

[CumminsPower59]

That must be the one, I seen it before when I was in there a while back, didn't even think of what it was for...

Thanks Mark!

[bmoeller]

Mark, how much for one for my e/c truck? I can wait til Michael's and get it from you there.......

[Mark Nixon]

$100.
Any particular COLOR you are looking for?
I might have it.

Mark.

[bmoeller]

Works for me.

Have paint gun, will travel.